SOURCE: wont recieve fax
NVRAM init NVRAM init returns all stored parameters in NVRAM to factory default values or to a default ROM value, depending on the variable, and performs a system reset. Performing NVRAM init can cause the product to violate local telephone regulations. Reset the language and country/region after performing NVRAM init. ENWW Service-mode functions 265 NVRAM init resets the following settings and information: ● All menu settings are reset to factory default values, including fax header and company name. ● Factory settings such as formatter number, page counts, and factory paper settings are reset. ● All faxes in memory are erased. ● All speed-dials, group-dials, and phone book entries are erased. ● All localization settings, including language and country/region, are reset. To perform NVRAM init 1. Turn off the product. 2. Press and hold down the * and MENU/ENTER buttons. 3. Continue to hold down the buttons while you turn on the product. Hold the buttons through the entire power-on sequence. 4. When Permanent Storage Init. appears on the control-panel display, release the buttons. 5. When the message Language appears on the control-panel display, set the correct language and country/region. 6. Allow the product to return to Ready before using the product.
SOURCE: faxing problems
Ok well here are two questions that are both going to get the same answer so here goes. Follow the link and go to the appropriate heading. Fax issues can be caused by so many issues but this is by far the best document I have seen to address them all and is in easy to understand terms. Make sure you check the fax settings just like it says and if still having issues please post again with the steps you have tried and what happened so that someone here can tackle that issue specifically. Please read and follow this first - works almost every time.
http://h10025.www1.hp.com/ewfrf/wc/document?docname=bpu02151&cc=us&lc=en&dlc=en&product=1153494&dlc=en&lang=en
SOURCE: will not recieve faxes
Hi i'm an ex HP employee
i got this information from HP's website
this is the link http://h10025.www1.hp.com/ewfrf/wc/document?docname=bpu02151&lc=en&cc=us&dlc=en&product=441125&rule=2043
hope it works out
thanks
SOURCE: We don't seem to be able to recieve faxes
Phone Co ran a check and it was due to bad fax line so they fixed it.
SOURCE: can not recieve fax
Defining the r/w parameters helped me to send/receive faxes. Go back in the previous threads to find how to set the r/w parameters on the hp 6110 printer. The parameters are under the system configuration of the service menu
27 views
Usually answered in minutes!
×