There are two resistors 310-3 10R on the power supply of the Europower pmp 5000, i need to know if it is 330k or 330om.

You can get the entire service manual for this unit here:
BEHRINGER PMP6000 SCH Service Manual free download schematics eeprom...

That , as far as I know, can only be bought through Behringer. They will probably NOT sell it to you or help you. THEY want you to buy a new one. This is one of those companies that has most of their semiconductors marked and labeled with odd numbers of their own so a technician will have no clue what values they are or where to get them. Behringer is the one main brand of equipment I have never been able to get ANY parts for other than colored resistors or diodes, some caps, switches and lights. Finding a schematic is easier done than to actually find replacement parts. Sorry, wish I could help more while being as honest as possible.

When using Speakon adapter cables with 1/4 inch plugs, the sleeve of channel A is the hot and not the tip of the plug. Inadvertent shorting of this to ground can blow that channel of the amp.

What is up is one of the two power amps is blown... I know this problem... It is USUALLY the rearmost channel which goes to the left Speakon faacing the back. Weak insulation between layers of the multilayer circuit board arcs and fries three transistors and a diode and sometimes a few more components. It takes a lot of skill to restore the module and is beyond most repair shops. A whole new module costs about $155 from Full Compass. The amp is an HCA2400 module, but you MAY need the Behringer part number to order it from Full Compass. Also please read my tip on Fixya for PMP mixers regarding the hazard when using 1/4 inch plugs from the Speakon connectors... the Channel A sleeve is the "hot", not the tip and if you ground the sleeve, goodbye channel A...

This is likely a power supply failure, possibly brought on by a failure of one of the amp channels.

This is probably close to your supply:

http://elektrotanya.com/behringer_sps600_power-supply_sch.pdf/download.html

Scroll down to "get manual" and click on that to download schematic. Ignore other download links.

Power supply probably failed. This is not a DIY for the inexperienced.

This will be close to your schematic: http://elektrotanya.com/behringer_pmh1000.pdf/download.html

Scroll down to "get manual" and click to download. IGNORE other download links.

Here:

http://elektrotanya.com/behringer_pmh1000.pdf/download.html

Scroll down to "get manual" and click on it to download. Ignore other download links for viewers on the page.

I don not know French.. I will get my wife to translate. I have schematic and can interpret transistor numbers. Schematic:

http://elektrotanya.com/behringer_europower-p0569_hca2400_sps1000_dpx_pmp-1280s_5000_sch.pdf/download.html

Scroll down to "get manual" and click to download. IGNORE other download links.

ALL LED's should NOT be lit all the time. If thsy are, there is a failure in the power supply.

plug headphones into the 1/4 inch main output jacks on the top... you will only hear sound in the left side headphone for each. This would verify the preamp is working.

Unit has wide range power supply will operate on 100 volts to 240 volts without any change other than possible plug adapter to mate with each countries receptacle standard.