Need codes for ht3916 to chage remotes - Durabrand HT-3915 System

Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. One among it has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily.
http://remotesearch.blogspot.com/
http://electronicshelponline.blogspot.com/
http://electrohelponline.blogspot.com/
Programming Notes
• If your device does not respond to the remote after trying all codes listed or your brand is not listed in the code list, use the Auto Code Search method to program your remote.
• Sometimes the first code that "works" with your device may operate only a few functions of your device. There may be another code in the code list that performs more functions. Try other codes from the code list for more functionality.
This is a trial and error procedure; and quiet time consuming. You might have to check different codes said for your device.
Search the site by type in the "brand name" to your device; in the "Search box at the top right of the display window " to get gathered related posts. ..

If the polarity of replaced battery have chaged, the remote won't work. Check it first.

Voltas remote..instructions are given behind the remote.

Off remote.
Press mode and - .
chages d unit of temperature.

Does your search engine work? "ht-3916 remote"

http://remotes.com/remotes/servlet/rs?v=1&o=c&o=c&a=Search&uid=0&m=ht-3916&uuid=A13131085717161

http://cgi.ebay.com/Replacement-Remote-Durabrand-Home-Theater-HT3916-/120598423208?pt=LH_DefaultDomain_0&hash=item1c1439e6a8

You can't chage it with your Direct TV remote control. If there is menu button in front of the tv, just go through the menu, and see the vedio options. From there you can change the input selection. If there is no menu button, you can't do anything without the help of remote control handset.

Normally all sanyo kits have two remote acces codes. One is Press Sleep Button on the remote handet and Menu button on the front panel of the TV simoultaneously.
Second is a tricky one.
Press Volume+/Vol_ to set the volume level to zero and press 'REP' on the remote control hanset aln loosen.
Keep pressing Vol+/Vol_ on the unit and press 'REP' on the remote control again.
Factory status will be displayed.
This is the service mode. You can adjust the parameters with the help of programe and volume control buttons.
To exit from the service mode, do the above said three again, unless the chaged parameters will not be stored in memory.
Another method is, if the hanset has a hidden key, usually at the lower side, which seems as a small hole. press it with a small stick to fit, may enter to remote code options.

Hi, drop down panel door. enter installer code. you need to know what zone it was on before, because I recommend you try to delete it first. so next delete then sensor remote button til you get to right zone, then "done" then use add button sensor remote button then if its the small remotes 2 botton press the 2 bottons. for botton press top 2.sensor group 01

CHAGE YOUR MAINS LEAD

do you know how to chage codes? if you dont know contact.this are the codes.

philips tv 011,056,043,017.

sony 001.