SOURCE: TH-50PX60U picture problem
Try to replace the Logic Scan board on the upper left side of your tv. The part no. is printed on the board and you can order it from Panasonic's Website. Also check the Service Manual for the part description and part no.
SOURCE: Sprayed Screen
This is for SCREEN REPLACEMENT on PROJECTION TV's:
I replaced the screen on my 62 inch projection TV for about $50 and the the picture quality is good! Have a sheet of plexiglass cut to the EXACT size needed. BEFORE installation it MUST be frosted on both sides by either a fine particle sandblaster or by sanding it VERTICALLY on BOTH sides with a power sander and a fine grade paper.
If this is only an OUTER protective screen and the image is projected on the inner screen then DO NOT frost the replacement screen, just install it.
SOURCE: can't get signal from drc6309 to video/audio input
I dont have a Solution but I have the same problem with my RCA portable dvd DRC6309. I have connected it to three different tv set and I get no Video but I do get Sound through the tv sets... I have sent an e-mail to RCA costemer support hoping for a solution. If I hear anything back I will post it here...
I bought my RCA DRC6309 about a month or two ago at a Wal-mart supercenter. They no longer sell RCA portable dvd players. That is why I contacted RCA directly.
SOURCE: Side BY Side Picture On TV Black And White
My mother-in-law sent me her unit with the same problem. The problem i had was you couldn't really read anything on the screen in the setup menu. I finally got lucky and got in the right menu and set everything to default settings and it went right back. Here are the steps to reset it without reading it.
1. remove all tapes and discs
2 if your unit scans for channels when you turn it on press return once
3.if it doesnt go to channel scanning you should have a blank screen
4.press the functions button once
5.press down twice
6.press the enter button
7.press the enter button again
8.press down once
9.press right once
10.press down 4 times
11.press enter once
12.press up once
13.press enter once and the double image should be gone
14. press the functions button twice to exit
hope this works for you
SOURCE: sharp Lc-26sb24u white screen with sound
You will get a white screen when you unplug the t-con from the main board. Doing so removes power to the LCD panel. Verify that all of your voltages from the power supply are correct. If they are, I'd look at the t-con board. It sounds like there is a problem with the t-con that is pulling down the main board.
41 views
Usually answered in minutes!
Could you provide more information in regards what the device is ?
Also the make and model of the device for reference.
Once we have this information we might be able to try and diagnose what the faults might be and the maybe able to offer you a solution.
Thanks
Garry
BSR Electronics
×