Questions & Answers for: LG 12v

...but ice fan was. I Pulled the freezer fan (there was no ice blocking it), I checked it with another 12v source and it did not spin. Then I checked the ice fan with a 12v source, it also didn't spin. ...

What type of power cord? What type of power cord does this monitor use? ...

...should be disconnected if E.H.T. is not producing then check +vcc at horizontal ic it should be 12v. if 12v is not present then check regulator ic 7812 insmps Hi sir lg 500g model j6810

LG VCR power up problem The power light flickers and it will not start, check smps volt +12v, -12v, 5v,3.3v, -22v.mast be have +12v, -12v, 5v.if not change or" connect extranal smps.

...power Was working put another load to wash and have no power You need to remove top and check for 12v and 5v,( put multimeter leads on wires one at a time) going into display panel from main board. ...

...will not light up. The breaker is fine, the outlet is fine. You need to remove top and check for 12v and 5v,( put multimeter leads on wires one at a time) going into display panel from main board. ...

...ooanel and lights does not common but the sound is present You need to remove top and check for 12v and 5v,( put multimeter leads on wires one at a time) going into display panel from main board. ...

...panel the washing machine electrical panel does not come on You need to remove top and check for 12v and 5v,( put multimeter leads on wires one at a time) going into display panel from main board. ...

...controller cable to the wired remote controller installation board as shown in the right picture. 12V SIG GND Red wire Yellow wire Black wire 12V SIG GND 4. After fixing the top part of the remote ...

...the voltages coming from the power supply board and got these readings from top to bottom: GND=0, 12v=12v, 12v=12v, GND=0, 24v=21v, GND=0, 3.5V= 3.3v, 3.5v=3.3v, PWR-ON=3.1v Does this indicate a ...