...attached. are there other bolts out of sight? there is a hidden nut on the backside of the engine 15mm if i remember correctly you dont have to take it off. remove the 2 15mm bolts and pry the ...
changing the alternator belt where is the tension adjustment on drivers side of egine under alt(15mm wrench head bolt in center or pulley with 13mm adjuster bolt)may have to lube tesioner bolt as they
...belt[s] without removing the front end of vehicle??? Thanks remove r-front wheel bracket 1 15mm nut 1 bolt note flat washer location under lower bracket not on outside but inside surface. ...
...TENSIONER to move,so i can replace the belt on a 1999 Chryster Town and Country? I believe it is a 15mm wrench or if room allows rachet and socket that you will find in the middle of the tensioner a ...
...belt on a 2001 chrysler 300M you need to remove upper radiator core support set on engine loosen 15mm bolt on front of alternator tensioner and 13mm bolt behind the tensioner pulley remove this ...
How do I remove the alternator Hello, Disconnect the battery, use a 15mm box wrench to pull tensioner and slip belt off, there is a top bolt and a bottom bolt on alternator to take loose, also 15mm. ...
...up,secure good with jack stands,block wheels and parking brakes on.Disconnect battery terminal,use 15mm wrench and 15mm socket,remove 2 bolts through transmission bell housing,remove nut from
...behind the belts you will see a bolt head that fits a 13 mm socket. You will have to loosen the 15mm nut on the face of the idler pulley then you can turn the 13mm bolt in to tighten , out to ...
Alternator change How can I get the alternator out? LOOSEN BOLT ON TOP OF ALT, REMOVE BELT BY USING 15MM ON TENSIONER, 2 BOLTS ON ALTERNATOR, MIGHT HAVE TO TAKE OFF A FEW THINGS IN THE WAY. WIGGLE IT ...
...to where it is supposed to be and then remove black plastic cap at bottom wiper arm and tighten 15mm ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions