Questions & Answers for: Chevrolet Cavalier 15mm

...accessory belt,the car has a four cylinder engine. they have a self adjusting tensioner usually a 15mm long handle wrench on the tensioen bolt pull up slip off ...

...belt routing and where the tensioner is and which way it swings to take belt off. sometimes its a 15mm and the longer the wrench the easier it is to swing

...worn one on my car To replace the belt push (rotate) the belt tensioner and remove the belt. Use a 15mm socket on the 4-cyl. engines and a 3 / 4 in. open end wrench on the V6

.... The rear...Remove the brake drum and use these two tools.....T-50 torx (star) "male" socket and a 15mm wrench and don't forget to unplug the rear. The hardest part about this ordeal is the front ...

...the alternator/serpentine belt, either by pushing the spring loaded belt tensioner back using a 15mm wrench (a pain in the arse), or by cutting it with a knife (much easier), seeing as you should ...

Driver side wiper does not work on 2004 Chev Cavalier Tighten the arm nut under the cover. 13mm or 15mm

what tools do you need to change a coil/bobine bobina for a 1995 chevy cavilier 8mm 10mm 13mm 15mm sockets wrenches

...2.4 starter. is it the small bolt or the smaller bolt? It's the small bolt, should have a 13-15mm nut on it. The smaller one is for the smaller wire, probably a 8mm

I need to know how to install a altenator belt for a 1996 chevy cavalier You need a 15mm socket and breaker bar to put the socket on in order to change the belt. put the socket on the bolt in the ...

...or similar, a 1 1/4" short socket for filter and a 5/8 socket for the plug... (i use 32 mm and 15mm respectively) note the socket for the filter needs to be very short with an extension, or do ...