...2000 gmc half ton, 5.3, push button 4 wheel drive. you can hear things going on when you push the button to 4 wheel drive but the front hubs arent locking in. replaced the actuator on the front diff. ...
...2000 sonoma 4 cyl two wheel drive. engine won't start makes a winding noise. had starter checked it passed noticed a loose post on solenoid. Thought maybe timing belt but learned that these come with ...
4 wheel drive My check 4wd light comes on and off while driving also all of the lights on the panel 4 w high , low 2 w ??? what can this be ? Check the electrical connector and see if its looseand ...
...4 wheel drive buttion . The light flashes but will not go in 4 wheel drive Check to see if the front diff is being engaged. Ther is a vac switch that come from the transfer case. It sits right on top ...
...2000 GMC Sonoma. This is a 4 cyl 2 wheel drive pick-up e Removal & Installation 2-Wheel Drive - 2.2L Engine Remove or disconnect the following: Negative battery cable Front exhaust pipe, if ...
...lights they do not even come on with all other dash lights when key is first tuned on , thus i have no 4 wheel drive for the lights check the fuse maybe the fuse is bsted and also check the
no lights on 4 wheel drive panel and 2000 gmc yukon will not go into 4 wheel drive check wires on the trans
...2000 gmc jimmy 4x4 stoped working. It wont go into 4 hi. the vacume pump under the battery is good. can hear and feel the motor switch from 4 low to 2 hi. any ideas? Is there a code reader for this ...
...2000 gmc and my 4-wheel drive will not lock in. the actuator and transfer case are engaging but the wheels are not locking in. What should i look forto see what the problem is? Ihave the manuals for ...
...4 wheel drive If your 4WD is vacuum operated I would check and probably replace the vacuum lines. They are most likely cracked or loose by now. To check them spray along each line with some carb ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
