...2001 Ford Taurus has begun to overheat, the overheating is a constant. It happens if im at idle or if im at highways speeds. The A/C has also gone with this. When I turn the heat on high in the car, ...
...ford taurus. Had battery and belt replaced. cuts off have a 2004 taurus, replaced belt and battery. However, problem is when the car idles. it cuts off. I was told the air conditioner replacement ...
...2001 ford taurus and it did the same thing a while back, call the dealer and ask them for the sensor that is behind the brake pedal. It is not the transmission .. cost less that 25 bucks to fix and ...
...2001 Ford Taurus LX. Idle goes up to 2,000 RPM. When the car is in drive the car goes to almost 4,000 RPM with out touching the pedel. Have a fuel pressure test done on it to find the problem. If the ...
2001 Ford Taurus idels low and stalls sometimes when stopping at a stop light sometime this will happen if the throttle blade idle hole gets plugged with carbon. if you take off the air inlet tube off
2001 FORD TAURUS IDLES BAD It will start to idle real low. Is it a sensor? i recently had this issue with my 2001 taurus dohc engine. when you drive it seems that everything is fine. when you stop, ...
Question about 2001 Taurus
...2001 ford taurus now car will not start 2001 ford taurus - 135k miles - Replaced all spark plugs and ignition coil pack due to running/idling very rough. The problem seemed to be fixed and car ran ...
Question about 2001 Taurus
2001 Ford Taurus SE loud noise when engine cooling fan turns on and off Out of nowhere, while idling, my 2001 Ford Taurus SE makes very loud noises when the engine cooling fan kicks on and off. HELP!!
Question about 2001 Taurus
2001 Taurus 3.0 dohc idles high sometimes and once in gear transmission seems to shift at idle. I think it may feel like that because it is idling high. For you high idle problem there are a few ...
...2001 ford taurus starts fine idles fine but when you put it in drive doesnt want to pull. First of all I need more information. But on a guess, I would say you might have a half shaft problem. Does ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions