it been some time since 4X4 was engaged? Have you had the fluid changed in the tranfer case? it should be done at 60,000 miles, worn out lubricant can cause these kinds of problems with transfer cases
Question about 2003 Sierra
transfer case switch goes blank, and no 4 wheel drive is possible. Fluids have been changed on regular basis. Don't use the auto function much, or 4 wheel drive for that matter. Any suggestions? The 4
...2003, GMC, Sierra z71, 4x4 truck Not sure how to do this. Is there a drain plug on the case somewhere? What type of fluid goes into the transfer case? The Z71 typically comes with the auto 4wd ...
...transfer case Unless someone has added fluid lately, check for a small fitting like piece sticking up on top of case that is a vent for case, it may be plugged. Can try air pressure to unclog it, but ...
transfer case to switch the 4wd system,you need to get the motor out and work with it in the work bench for furter information about it explain to you dealership parts guy cost around 130 bucks and if
2003 Sierra 2500hd transmission or transfer case making grinding noise (sounds like a bearing going bad) it becomes louder when i give it gas. i checked the fluid in the transfer case which looked ok,
...gmc transfer case If You look at the transfer case you will see a Plug which requires a hex socket( allen socket), you should see 2 of them, one up high and another one closer to the bottom. remove ...
2003 Sierra 2500hd transmission or transfer case making grinding noise (sounds like a bearing going bad) it becomes louder when i give it gas. i checked the fluid in the transfer case which looked ok ...
Question about 2003 Sierra 2500HD
2003 sierra 2500. front drive shaft will not spin with a load against front end. new actuator, it's locking in. new encoder motor, it;s locking in. just had new clutch plates and bearings and seals ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions