sound when turning I have an 04 Envoy that has started making a clunking sound when I turn Check for worn or damaged CV ( constant velocity ) joints at the ends of both front axles covered with rubber
The boot just inside the brale disk is throwing grease all over the under carriage. Is this the CV joint? yes, and if you change the boot before dirt gets in, you may be able to save the joint....Do ...
...2004 envoy required a little bit of works remove the wheel loose the tie rod end, lower ball joint, axle nut separate the steering knucke assembly from the axle remove the axle, you may have to use a ...
2004 GMC ENVOY Steering wheel shaking, could this be the ball joints or alignment? I know it needs an alignment,because the toe is out. Shaking of the front wheels indicates either an out of balance ...
...GMC Envoy 2004 I have listed an image for the upper and lower while they are still assembled on the knuckhousing. Not sure of you have 4 wheel or 2 whel drive, and if you need the upper or lower ball ...
...Envoy is at the front wheel assembly. The upper ball joint is very close to the tire, even with standard size tires. Go to www.trailvoy.com and do a search on tire size, I believe someone posted a ...
...GMC Envoy 2004 model. since few days i have notice that if i drive in a speed more than 100 KMPH, there is a slight vibration. please advise what could be the reason... possibly a bad u-joint. ...
Question about 2004 Envoy
2004 gmc envoy-while in "a4wd" reversing slowly, it didn't want to go then a loud thunk and shudder it backed up a bit.let off the gas immediately and tried easing into it again. same thing. i drove ...
Grinding sound from rear end of 2004 gmc truck? What is causing the sound? could be brake shoes /pads badly worn, failed bearings , no oil in the differential, failed "U" joints
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions