Questions & Answers for: 2005 chevy impala heat working

...2005 chevy impala LS...just a couple of days ago its begun jerking when shifting gears, only after I have driven the car long enough to heat up...when its cold it doesn't ****. Anyone have any ...

chevy impala, I replaced the switch relay, located behind the ignition lock cylinder, and the heat gauge works perfect now. You have to take apart the dash to switch the part.You can also try AutoZone

...2005 Chevy Impala,,,,air worked fine all summer, blower works, just no heat on drivers side and minimal heat on passenger side....this car is nothing but problems GM Yuck! I'm surprised you haven't ...

2005 Chevy Impala driver's side heat blows cold. 2005 Chevy Impala driver's side heat blows cold, but works on passenger side. Was told a vent is probably not opening to allow for the heat to get to ...

chevy 2005 impala i have a chey impala 2005 my heat on the driver side stop working and blowing cold air out what is the cause of that? sounds like you have a bad actuator motor that make temp go hot ...

...2005 chevy impala 3.4 liter. the heat only works when giving gas.changed stat and still nothing. the pipe that runs from the water pump to heater core doesnt get hot untill you give it gas. i opened ...

...2005 Chevy Impala has no heat. The blower works good and the thermostate seems to be working. I sent it in to have the front brakes worked on and it came back with no heat. Is there a fuse or breaker ...

2005 chevy impala passenger side blows heat out continuously, driver's side works fine with heater & AC Hi, My 2005 Impala has the heat blowing constantly from the passenger side -- no matter ...

...2005 chevy impala will run and drive, reverse works also, but it seems after it heats up it wont go, the engine just revs, if i shut it off and wait 5 or 10 minutes, and start it, it will go again, ...

...2005 Chevy Impala? I have a 2005 Chevy Impala. I drove it yesterday and the windshield wipers would not stop going. I never turned the wipers on, and they were moving even when the switch was in the ...