Questions & Answers for: 2008 chevy truck express 2500

2008 chevy express cargo van i went to replace the brake light in my 2008 chevy 2500 express cargo van, and I couldn't get the tail light off without dismantling the entire rear portion of the van. Am

2008 chevy express 2500 with a 6.0 crank sensor problems i have a 2008 chevy express van with the 6.0l motor and it keeps going through crank sensors. tried napa ones and the last 2 were GM ones. ...

chevy express 2500. While changing the brakes on my van, a rivet and clip pulled through the rear wheel dust plate, I'm unsure on how to fix this as now one half of the shoe is rubbing agains 2006

...chevy express 2500 I replaced the bulbs fuses and brake light switch but the problem still persist. the third brake light still works the flashers and turn signals blink very fast Sounds like a bad ...

...chevy express 2500 po719 how to fix that might start with replacing the brake switch at the pedal, it usually involves the torque converter not locking up due to the vcm not sencing the brakes not ...

...2008 Chevy express 2500 Tested fuse box under driver seat no power there for brake light turn signal right side Body Control Module (BCM) is located in the Lower right side of the instrument panel ...

2008 Chevy express 2500 Tested fuse box under driver seat no power to there for right blinker and brake light body control module is on the passenger side of the dash - remove the passenger lower knee

2008 Chevy express 2500? I have no power at fuse box under driver seat for right-hand break and Blinkerlight It is tucked up under the dash on the passenger side. You will have to remove the passenger

...chevy c-2500, replacing hydro assist. have master cylinder and hydraulic hoses detached. have removed the four nuts under dash. need to disconnect the push rod from the brake pedal. manual and videos ...

2008 Chevy express 2500 6.0L, USA with ABS, Rear wheel drive. I could only see only Park brake and rear brake lines going to the wheel hub. I did not find the WSS wire going into the rear wheel. So, I