Questions & Answers for: 2 port valve

Question about Electric Powered Convection Steamer

1 Answer

...valve has extra port,not sure what to pipe to the extra port,steamer will not fill with water,water just runs out of new valve down drain.steamer model 24cem24 parker valve no.22244 The correct ...

Ad

port valve is located on the A/C receiver drier manifold and tube assembly. The low pressure service gauge port valve is located on the manifold of the A/C compressor manifold and tube assembly at the

Ad

trying to find ac service ports on 03 lincoln ls cannot find ac service ports on 03 lincoln ls the AC service ports are capped with either blue or black caps... and being yours uses R134A, on the ...

...or component. The Schrader-type valve core can be replaced if the seal leaks. here is a typical system. #1 is the low side charge port. One-Piece Service Gauge Port Valve Two-Piece Service Gauge ...

Question about 1996 Town Car

1 Answer

...port an did not see the schrader valve. So how do I change this type of valve. 2003 GMC PU 5.3 Some of the valves unscrew. you have to replace the top of the port. Look closely at the port you will ...

Question about 1996 Town Car

1 Answer

...valve) then to the "Tank" port on the Evap canister (they are usually marked) The other canister port marked "Purge" goes into a Vapor Contol Valve. That Valve has three more ports. One to the carb ...

...valve. This long suction port provides increased air intake which results in improved suction efficiency and higher torque generation. The surge tank and one-way valve are provided. When engine is ...

...of the rear tire and left open. The ports at front of 1&2 usually connect to the fuel valve and actuate the vacuum portion of the fuel valve, that's the small port on the back of the fuel

Question about 1996 Town Car

1 Answer

...port closest to the side mounted installed pressure valve is the correct one. How far into the insulation is the plug for top mounting the valve? Of those two access ports you see, one is for the ...

Question about 1996 Town Car

1 Answer

...valve is off check the ports in the manifold for debris and clean out the port. you can start the car and you should hear exhaust gas coming out the port. this will indicate an unplugged passage. if ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Electrical Supplies Experts

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you an Electrical Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...