Questions & Answers for: 3m polygun hot melt gun

...3M Polygun EC with the modules has quit heating up. The cord and plug look good. Any ideas:? You'll have to look at the plug all the way to the heating element. It's possible it's melted, also it ...

...3M polygun definitely works, but I do not know the product number. Do you know what type of hot glue i should be using? 3M Hot Melt 3764 is the correct adhesive for PVC. They sell PVC cement at home ...

I have bleedby so bad I can pull the plunger back I have bleed by so bad I can pull the plunger back with the trigger pulled. This occurred all of a sudden. I swapped an old plunger assembly but it ...

...3M Polygun II hot melt gun. Thanks for your question! I'm sorry that you haven't received an answer yet. The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go ...

...allow it to heat up. When the gun reaches the correct heat level you will be able to pull the trigger of the gun which will pull the stick into the gun. This will only happen if the gun is hot

what is wood glue sticks Wood glue sticks are hot glue sticks which are specifically designed for use with wood (such as for glueing together a birdhouse).

Need a new regulator kit part number 9204 http://www.hotmelt.com/products/3m-9204-pg-regulator-kit

...hot melt glue gun purchased 10 nyears ago and now cannot find a supplier for the refills.The glue stick are tubby,approx, 2 inches long, can you help please. Many Thanks IUrene Bell Check with ...

...3M Polygun ll Benchmount assembly.\r\nThe connector that attaches to the outlet of the hot melt. It has a 45 degree down pointed angle. To this adapter, you then apply the desired dispense tip. Like ...

replace the heater element in a polygun Hi:You directed this question at me, but unfortunately this isn't my expertise and I am unable to provide you with a real solution at this time. Hopefully ...