Questions & Answers for: Chevrolet Impala liter chevy vacuum hoses

...to the engine block. it is L shaped,my engine is a 3.8 liter v6 in a 2000 chevy impala ls. With what was given try to tighten hose if still leaking try replace that hose may be old and ...

liter v6 in a 2004 chevy impala ls if the hose has a small hole in it, it is no problem to replace, any parts house can get you a replacement hose, let car cool, loosen clamps remove old hose, install

liter chevy engine, Impala. hoses look good, new water pump. what is there up behind there to leak? the heater hoses pass through the firewall into the heater core, which resides inside the dashboard.

...vacuum module on a 2001 chevy impala located and how do i replace it? that has not been used since the 70's on cars without a computer controlling the transmission if one was present the part would ...

...chevy impala 3.8 liter - remove the engine cover. As your standing in front of the vehicle it will be located on the passenger side of the engine inbetween the intake plenum and the valve cover. It ...

...liter 2002 chevy Impala Check for vacuum leaks at intake, and snorkel. Moniter short term fuel trims. Check Freeze frame of when code P102 sets. Make sure you are using stock air filter system ...

...Chevy impala with a 3.4 liter engine Misfire reasons. Bad ignition coil (there are 3 of them), bad spark plug, bad spark plug wire (most common) defective fuel injector, intake manifold vacuum leak, ...

...It seems to be connected to the engine block. It is L shaped, My engine is a 3.8 liter v6 with a supercharger in a 2004 chevy impala SS. What is this hose called? It is your water pump bypass

Location of thermostat on 2005 chevy impala 3.4 liter Follow your upper radiator hose into your engine block that's where it will be. Hope this helps good luck

...chevy impala has been dying at stop signs a few times, now transmission wont move in drive it will move in reverse fluid level ok thinking a vacuum line leak somewhere? checked fluid only Connect ...