...sprocket timing hole into timing chain housing timing hole. If timing pin does not fully index, the camshafts are NOT timed correctly and the procedure MUST be repeated. With timing pins installed, ...
...hole behind the sprocket at about 10.30 o'clock. When both timing pins are in their locating holes, the top and bottom of the engine is in-line. This information is only to set the engine up and not ...
...up with a line behind it cast into the oil pump cover. The camshaft sprocket has a marking that says UP with a hole. Use the hole to sight the timing mark on the cam bearing cap behind the
...hole in sprocket w/ marks on cam seal housing, my cam sprocket has two sets of holes about ~180deg apart (one hole has pink paint mark by it). I found on internet a copy of factory manual ...
...sprocket and timing chain outer surface for reassembly, then remove the chain. Clean the old sealant off the bolt with a wire brush. Clean the threaded hole in the camshaft with a round nylon brush. ...
...sprocket locator hole are aligned to the marks on the engine block or timing chain dampener. This is the No. 1 piston at TDC (No. 4 firing position). Unfasten the camshaft sprocket retaining ...
...hole of the oil pump drive sprocket with the oil pump groove-2.4L (2AZ-FE) engine Fig. Insert a bar to lock the sprocket in position-2.4L (2AZ-FE) engine Put a bar in the adjusting hole of the oil ...
...hole by the sprocket then your bar is sealed and dont need to lube the sprocket--but make sure you have oil in your chainsaw's oil tank--that lubes the bar--chain oil is a must--dont use a chainsaw ...
Question about 1991 Lumina
...hole in the sprocket and hammer it out It will not take all that much force mark the sprocket in relation to the shaft as the holes in the sprocket and shaft do not always match and it could be 180 ...
Question about 2001 Cavalier
...sprocket timing hole into timing chain housing timing hole. If timing pin does not fit easily, repeat procedure. 23. With timing pins installed, raise and support vehicle with jack stands. 24. With ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions