...at 65. After 1000 miles turn 90-degrees. 12pt (m12) 1st 29 lb-ft, 2nd 43, 3rd turn 90-degrees, 4th turn 90-degrees, warm engine and turn another 90-degrees. After 1000 miles turn ANOTHER
i need the head bolt torque settings can anyone help 2.4L and 2.7L is: Step 1- 29 ft.lbs. Step 2- 90 degree turn Step 3- 90 degree turn 3.4L is: Step 1- 27 ft.lbs. Step 2- 33 ft.lbs. Step 3- 90 degree
...90 degrees 4. Big end bearings: Renew bolts / nuts = Yes 5. Big end bearings: Stage 1 = 30 Nm 6. Big end bearings: Stage 2 = 90 degrees 7. Flywheel / driveplate = 60 Nm + 90 degrees (use new bolts / ...
...lbs. step 2 an additional 90 degrees step 3 another 90 degrees with new head bolts step 1 46 ft lbs. step 2 loosen all bolts step 3 14 ft lbs. step 4 an additinaol 90 degrees step 5 another 90 ...
torque specs for a head on a 1997 bmw 528i with a 2.8l (29.5 lbs)40 nm and wait 20 minutes and turn 90 degree wait for 20 minutes and turn additional 90 degree for "IRON BLOCK" . "Alumn. Block" is (22
...90 degrees. Retighten to 29 nm. Paint spot of white paint on front of bolt head and tighten additional 90 degrees and then another 90 degrees (Total 180 degrees) You won't be far wrong anyway. Loosen ...
Question about Motor 2004 Sonata
...90 degrees stage 3 ... angle tighten + 90 degrees stage 4 ... angle tighten + 90 degrees stage 5 ... angle tighten + 45 degrees Corsa 1.4i Engine code Z14XE 2000-2004 Bolts must be replaced after ...
90 degrees checked with angle gauge/protractor 4 corners? Each corner is 90 degrees. Divide by 2 for the cut on each piece for 45 degrees. If you are wanting a 90 degree angle for the finished product
Question about Motor 2004 Sonata
...90 degrees + 90 degrees (in 3 steps of 90 degrees each) Main bearing cap bolts torque: 30 Nm (22 ft-lbs) + 90 degrees Connecting rod bolts torque: 25 Nm (18 ft-lbs) + 90 degrees Intake manifold bolts ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions