Questions & Answers for: Daewoo Lanos 97 neon brake lines

abs light my abs light on my daewoo lanos has come on and not going off what do i do has to to a machanic for a check up all the brakes and lines and then he will reset it they come on if there is a ...

front brakes stick on Daewoo Lanos sx 1.6 after driving for about 10 minutes the front brakes stick on and the brake pedal is solid either your calipers are sticking and need replacing. OR the hoses ...

severe bearing noise from front wheel bearing/cv Severe bearing noise from front wheel bearing/cv joint area.Cv joint still lubricated,I tend to think axle support bearing is dry & on the way out,but ...

puting in new brakes (how)? should we clamp the hose then undo the nut ? Please don't clamp the hose or you may damage it. Remove the bolts holding the caliper on and support it with a wire or bungee ...

binding brake how to adjust hand brake on daewoo lanos 1.6 (s reg) driver rear binding hand brake cable adjuster lives under centre console at rear 10mm spanner required unadjust this and then remove ...

brake lines rusting away), or damage, if the car ran over some debris in the road. The front brakes have flexible rubber lines attached at the wheels, so the car can turn, and the lines 'flex' or move

I wish to purchase a set of front brake dish and to replace the servo. Where can l purchase it in Manila, Philippines My unit is a Daewoo Espero 1999 model any parts store on line...or E-Bay...

...neon replaced master cylinder did not bleed brakes it worked fine for couple of weeks but now its doing it again do i need to bleed the brakes If you replaced the master cylinder, then yes, you would ...

why do my brakes make a noise whenever i try to stop? 2000 4 cylinder, two doors, my brakes are working but any time i appll them they make a noise The brake linings maybe worn out and a metal to ...

...brake lines specifications We are not sure how many brake lines, the lenngth of each brake line is needed for Lanos 2001. Measure the old ones or cut to length while fitting new ones using the proper ...