Questions & Answers for: ac button

...AC button to clear the screen 2. Press and hold the Set % key until Set appears 3. Press the Tax+ key 4. Type in your tax rate (including decimal point) you wish to calculate 5. Press Set % step 1 ...

...ac button stays illuminated my yellow ac button stays on and im not getting any cold air from the vents check that your AC belt hasnt snapped. Check ur AC fuses and u may be out of gas if non of the ...

...AC button switch blinks AC won't work My daughter's 1997 Talon A.C. on dash pushbutton blinks when she turns on the AC. AC won't work but button blinks. Freon (spelling? sorry) is good. What could be ...

AC button on. Fans still don't come on when AC button is pressed but will run when engine is at driving temp.What next ? Also when AC button is pressed engine does idle up a little as if compressor is

...ac button connector with it still pluged in start the car and turn the ac button on wiggle the ac connector if the light comes on and off it's a loose connection in the harness/connector at the ac ...

...AC button it beeps and the economy button lights up and blows outside air from the vents. How do I fix the AC? Remove the negative battery cable to reset the ac control,then if it does this again,the ...

...AC, 9 button on TV remote lowers the temp on AC (as well as change channels), 8 button changes FAN and COOL setting (as well as change channels) , 5 button on TV remote raises the temp on AC (as well ...

AC on off button does not work The AC engage button is not working, we checked all 6 fuse panels and there were no blown fuses, so we replaced the AC assembly, the entire plug in climate control thing

...change light. What are you saying, the ac button light stays on when the ac is off ??Its supposed to be on when the ac is on to tell you the ac is on.It will also be on in defrost mode on most

...AC power button is depressed. Will turn on when pressure is applied to the button or when wiggling the button It sounds like a faulty button. Try and bridge the wires on the button and see if that ...