Questions & Answers for: Chrysler actuator heat

...heat Sounds like the heater blend door. The actuator may be stuck or broken. The actuator opens and closes to adjust for the heat setting in the car. You might be able to take a coathanger and ...

I have town & country 1998 with heat on drive side and not heat on passenger side what is wrong ? with door actuator both levels are on heat Vacuum leak going to one actuator probably

I have to flip the heat actuator manually to get the fan to blow on the windshield instead of from the dashboard. Where is this actuator switch located exactly? Me too

...heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified ...

...heat works on my 2004 Chrysler Sebring but it only blows out from my front dash only and not the floor or Front dash defrost? More than likely a bad vacuum or electric actuator, or bad vacuum line. ...

...heat on the drivers side Suspect inoperative blend door actuator/motor not working properly. There are several actuators attached to the heater box assembly that control air flow direction and ...

heat on driver side not on passenger 2007 Sebring If you have a dual range heating system (separate settings for driver and passenger), your blend door actuator for the passenger side is not working. ...

...two actuators and they work fine. Has to be blend door actuator. Looking to find and replace or ,annually switch to heat for the winter. In raking yard ,or some call it recycling yard ,all the

...actuator for heat is located up behind the glove box. These actuators are made of plastic and tend to strip. They are not expensive, and you can find videos that will show you how to replace. Good ...

...heat If these are electric actuators (you didn't specify year), there is an initialization procedure which must be followed before installing it, otherwise it may be locked at one position (open or ...