...ADF and press Cover open sensor to see if the lamp lights. If not, the error is caused by the defective lamp. 5. Is the optical unit dirty? 6. Are the cables damaged? 7. Are the connectors connected ...
...open the ADF and push in the cover open switch. if one if off, replace it or the lamp inverter swap the cameras over to be sure the fault follows to an E2 replace the optical unit good ...
...cover open. If you see the lamp come on, it's likely a cable or CCD problem, though it can be caused by a really dirty reference strip or mirrors. I've never seen one that dirty but it's mentioned in ...
Question about fi-5750C Flatbed Scanner
...ADF cover, at the from of the rear camera you will see the board held on with 2 screws, there have probably come loose. you will need to tighten them up with the board in the right place to allow the ...
Question about fi-5750C Flatbed Scanner
ADF cover is being closed. Note: Cleaning should be done approximately every 10,000 sheets scanned, though it may vary depending on types of documents scanned. More frequent cleaning is necessary when
ADF cover is being closed. Note: Cleaning should be done approximately every 10,000 sheets scanned, though it may vary depending on types of documents scanned. More frequent cleaning is necessary when
ADF cover is being closed. Note: Cleaning should be done approximately every 10,000 sheets scanned, though it may vary depending on types of documents scanned. More frequent cleaning is necessary when
Question about fi-4750C Flatbed Scanner
...ADF cover open sensor as shown below to see if the ADF lamps light which has to be replaced. I would recommend to contact an authorized FUJITSU scanner service provider or the dealer where you ...
...ADF paper chute),Guide P ASSY (Sheet guide), Feed roller cover (plate guide) and Brake roller cover installed correctly? 4. Clean the Feed rollers, Eject rollers,Plastic rollers, glass surface and ...
Usually answered in minutes!
109 Questions
61 Questions
76 Questions
33 Questions
26 Questions