Question about 2002 FLHR - FLHRCI Road king
...adjust the throttle cable, you must insure that it operates correctly. Twist the throttle to the wide open position, with the engine OFF of course, and release it. It must automatically return to the ...
adjust the throttle & idle cables on a 2009 sportser Each cable has an adjuster near the throttle grip. They may be covered by a rubber boot. Slide the boot up so you have access to the adjusters.
Question about 2005 FXD - FXDI Dyna Super Glide
...adjust the throttle cables could result in the loss of control of the bike resulting in serious injury or death. If you are not sure of how to do this, find someone who knows how to do it. You don't ...
Question about 2006 XL 1200 C Sportster Custom
...Adjust the throttle cable first. Adjust it until it has just a bit of freeplay in the cable. As you attempt to twist the throttle, you should feel a little freeplay before you feel the throttle start ...
...connect to the throttle body. When cables have been install and all parts reassembled you can carefully adjust the tension on the cables until the throttle responds the way you like it. Hope this ...
...cable runs through that. loosen the screw and adjust your throttle cable accordingly. "Note-there should be at least a 1/4 inch of play on the thumb throttle on the handlebars"......good luck ...
adjust throttle cable or kick down cable how do u adjust throttle cable or kick down cable on a 94 olds ciera Its non adjustable you have to replace the cable if it is worn; the only cable which can ...
...adjust the throttle cable slack on a Piaggio ET2, you will need to locate the throttle cable adjuster. The adjuster is typically located near the carburetor or the throttle body. To adjust the slack, ...
...Throttle valve cable adjustment:Place throttle body in idle position. Press cable lock button to release cable. Pull cable conduit toward rear of vehicle until wiper is completely retracted into end ...
Question about 2006 FXDI Dyna Super Glide
...adjust the throttle cables turn the cable adjusters and jamnuts as short as they will go so that both cables will have zero adjustment at the start of the adjustment procedure. THEN with the front ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions