...grip shifts and a new x-9 derailleur. I can't get the chain higher than the 7th largest gear(I have 9 gears). Suggestions? check ur cable tension or the high and low adjustment screws on the ...
...Shift your bike into the highest gear and release the cable. Pull it taut and re-tighten it. Flip it over and shift into your middle cassette cog while cranking the pedals. Use the barrel adjuster on ...
...9 sprocket cluster. When I am shifting up or down sometimes the chain will jump past the middle sprocket. Other times it will float back and forth between 4,5 or 5,6. Any suggestions? make sure ...
Question about SX5 9-Speed Twister Mountain Bike Shifter Set - 00.0000.200.781
cable for SX5SRAM-9 deore gripshift having trouble re threading new gear cable on deore SX5 SRAM-9 gripshift, unable to see correct angle to point new cable through grip ? can you help at all? took it
Question about X7 Mountain Bike Rear Derailleur
...adjusting the cable tension on my new SRAM X-7 derailleur installed on my KONA Coilair with a 9-speed cassette, however the derailleur is only functioning on six of the nine cogs (the six high end ...
...9 and does not move, but it shift very well The Scale, known as the gear indicator, has no bearing on the function of the shifting. It is a simple device that connects to the derailleur cable and ...
Question about 3.0 Comp 7-Speed Twister Rear Mountain Bike Shifter - 00.0000.200.656
sram twist shifter on left #2 isnevr in the same place have constantly play with it every time i shift back to second http://www.parktool.com/blog/repair-help/shift-levers-shifters http://www.parktool
SRAM Rival Rear Derailleur stays on the large rear gear when shifting from low to high gears. Sometimes the gears doesn't seem to change at all. I've already taken the bike to Performance bike
cable. Shift it so there is no tension on the cable and see if you can manually pull the cable freely through the housing. If not, some preventive maintenance or replacement is needed. That's shop
...shift that poorly with SRAM shifters. It is not the best - but it's not bad. If I had the bike in a repair stand I would be looking carefully at the following after affirming that the ...
Usually answered in minutes!
6 Questions
4 Questions
4 Questions