...9. Shift mechanism arm is broken. 10. Shift drum is broken. For more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck ...
...cable retainer assembly from the shift release arm. It is tight, but wiggle it and it will pop out. Completely remove the bolt in the side of the arm. Shoot some lubricant onto the arm and tip of the ...
...9. Intake manifold leak. 10. The gas cap is not venting properly or fuel tank venting system blocked. 11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent ...
...9. Shift mechanism arm is broken. 10. Shift drum is broken. For more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck ...
yz85 clutch adjustment My clutch won't disengage so even when I have it pulled all the way in the bike won't roll freely... Hi, Anonymous for this scenario you will need your service/owners manual if ...
mixture srew settings on yz85 just wondering where to put mixture screw is in rich and out lean any info cheers Hi, Anonymous for this scenario you will need your service/owners manual if you can't ...
9. Air/fuel mixture screw improperly adjusted. 10. Accelerator pump damaged or not working. 11. Water or dirt in the fuel system, carburetor or filter. 12. Restricted, blocked or kinked fuel line. 13.
Question about 2005 yZ 85
...adjusting screw set too low. 8. Air/fuel mixture screw set too lean. 9. Idle port, transfer ports, slow air jet clogged. 10. Slow fuel jet clogged. 11. Faulty fuel pump. For more information about ...
...9. Fuel injectors clogged. 10. Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary. 11. Check battery terminals for damage or corrosion, ...
...9. Dirty air filter. 10. Intake air leak. 11. Water, dirt, or rust in the fuel system, carburetor and/or filter. 12. Old dead or bad fuel. 13. Fuel tank vent system plugged or carburetor vent line ...
Usually answered in minutes!
20 Questions
5 Questions