Question about 13HP 338 Cc Portable Generator # FG6000MK
generater will run, but no power output check avr / brushes if it has them if not capacitor and diodes on the end of the armature
...breakers and test any capacitors in system wiring. Some brushless systems use capacitors to excite armature. If diodes in armature are faulty there will be no output. Generators output two circuits ...
Question about 13HP 338 Cc Portable Generator # FG6000MK
...does shaft couple to generator The shaft to engine has male tapered end and fits very tightly to armature of gen. Remove stator and remove center bolt thru armature. Place a piece of hardwood ...
...converting the DC off the generater to AC for your output . If the engine runs ok and the armature in the generater spins ok and you don;t have a million hours on it should work at least ...
...spinning by hand. put it back together and it still just hums. what next? I would say a bearing or armature mount is loose. When the power is applied the magnetic fields are pulling the armature up ...
...speed. Is there anything I can check or replace? Or is it toast? I would think it has burnt the armature out, it is probably beyond economic repair,
Question about FG7000MA 7000 Watt 13 HP 389cc Portable Generator
Torque setting for armature bolt 7000 watt generator Repaired engine and I am installing the generator alternator to engine shaft Rotor Center Bolt 5/15-24 Bolt 12-20 ft-lbs.
Question about FG7000MA 7000 Watt 13 HP 389cc Portable Generator
Mcculloch electric chain saw parts do you sell the armature for Mcculloch electric chain saw model 250-14? That part is not available and most parts are discontinued. Time for a nice new one. ...
Usually answered in minutes!
36 Questions
23 Questions
13 Questions
15 Questions