Good armature maybe needs new brushes I have a G4 kirby. Can you replace the brushes? If so where can I buy them? My armature looks good but I think my brushes are bad. I cleaned the armature with a ...
...bad! I tried to replace my fan, but I stripped out the spot where you put the wrench on the motor armature. Once I knew that was ruined, I put vice grips on it just to remove it, but it still
...retaining bolt that also drives the belt. >The part that I can't figure out is how to grasp the armature side without damaging it. >Is there a special tool or do I just stick the blade of a screw ...
Question about Commercial Guardsman C1433 Upright Vacuum
...side of the black motor housing to allow a special tool (or a screwdriver) to fit on a slot on the armature to keep it from rotating while the pulley is unscrewed. You MUST NOT touch the magnet wire ...
...The carbon brushes in your motor are worn out and "sparking" against the motor armature. DO NOT operate the vacuum in this condition or you may damage the armature so badly it ...
How to remove a Kirby Heritage II Armature I have a Kirby Heritage II that has stopped working (does not run at all). After disassembly I think one of the carbon brushes has worn down. While I have it
Question about G4 Bagged Upright Vacuum
...giving off blue sparks then stopped working altogether -any ideas what could have failed? moto? armature? carbon brushes? a fuse :) armature and carbons, 79.00 arm 14.99 carbons, should change ...
motor armature for e series motor I'm needing an armature for my e series motor. The factory never made the armature available for purchase. We provide a service by turning them on a lathe. If your ...
Question about E series Canister Wet/Dry Vacuum
Bosch bulldog 11228vsr can you help me with this unit One of the long male push end wires for the armature broke. To remove the broken piece I needed to disassemble the unit. The armature had what ...
Question about E series Canister Wet/Dry Vacuum
good. If all batteries are good, check the carbon brushes if they still able to make contact to the armature of the motor. If the carbon brushes cannot make contact or all worn-out, replace the carbon
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions