...windings have probably been cooked? so when cold seem o.k. but at operating temp expand and the armature receives less power. Have you recently tried starting from cold with a poor battery? if so ...
...electrical short in your system. also you also may have something wrong with your moonroof sliding
...it is just the solenoid, but most of the time it is either the carbon brushes or the starter armature that has an open circuit on the
...MOTOR BRUSH,ALOT OF TIMES TAPPING THE STARTER MOTOR MAKES THE HEADLIGHT COME ON.MAY NEED TO CLEAN ARMATURE RINGS ON STARTER CARBONED UP
...armature tested with a growler and field coils, and brush plate with an ohm-meter for opens, shorts or grounds. Replace brushes if less than .438" It is generally cheaper to overhaul/refurbish a ...
...armature tested with a growler and field coils, and brush plate with an ohm-meter for opens, shorts or grounds. Replace brushes if less than .438" It is generally cheaper to overhaul/refurbish a ...
...armature tested with a growler and field coils, and brush plate with an ohm-meter for opens, shorts or grounds. Replace brushes if less than .438" It is generally cheaper to overhaul/refurbish a ...
...even with a tap. ? The starter was bad, now is worse. (Usually this tap on it solution means the armature is warped. [main shaft] Could ONLY get worse) You can whack it real good to maybe start it ...
Question about 1998 316i
when i turn the key pull the starter motor to have the solenoid checked for bad contacts . Have the armature checked for a dry joint in the bar windings
Usually answered in minutes!
789 Questions
796 Questions
708 Questions
690 Questions
600 Questions