...to repair a A701A and the motor seems to be faulty. Do you know if it is still possible to get a armature for this motor? Regards, Graham Hello graham. yes we can supply the armature to A701 or ...
...armature tested with a growler). Reading between armature windings and stator (earth) is 16Mohms. Any ideas if this is okay? I know this may sound stupid, but check that you have the earth wire from ...
Question about KM800 Major Classic Stand Mixer
...I put them back jrichards - I hate it when that happens! It seems that power is not getting to the armature from the brushes so I would suspect that one or both of the brushes is (are) not seated ...
Question about KM800 Major Classic Stand Mixer
burnt armature on Kenwood pro. pm900 got replacement but burnt armature on pm900 got replacement armature but the shaft is not long enough. Kenwood say it the only one listed! If when laid side by ...
Question about KM800 Major Classic Stand Mixer
...Started spinning but does not sound correct. When you took out the brushes did you clean the armature? Sounds like you need to remove the brushes and using crocus cloth (available at Lowe's) ...
Mixer just hums, does not turn Brushes appear to be in good shape, Clean the armature with emery paper. Armature spills freely. mixer arm turns freely. Help!! has the armature worn down so the ...
Sparking at brushes I have a small router. The armature lights up when you turn it on. The flashing extends almost halfway around at each brush. Because of this I replaced the brushes, it didn't ...
KSM90 Mixer knocking sound I have torn down completely. The Armature seems to be hitting the Stator on lower speeds. Then levels out on higher speeds and doesn't make contact. I think it is either the
mixer not working but smell burn what is the problem smell burn and not working Winding short with the armature. Replace the armature. Gopakumar Gopalan Google
Question about A200 Stand Mixer
K5SS won't run on low speed and runs slow at high speed. Phase board, field coil, or armature? My mothers KitchenAid K5SS one day just locked up at the stir position on the switch and will only start ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions