hub not working properly The hub is not working properly unless I connect a certain cable Maybe your hub port is not using auto sense port. Maybe you hub port is not auto sense.
Question about P4350 All-In-One InkJet Printer
...the paper guides. Make sure you adjust the guides each time you change paper sizesYour printer can automatically sense when A4, letter, legal, executive media or B5, DL, and #10 envelopes are loaded ...
auto sensing does not work. dryer continues to run auto sense does not work. dryer continues to run until the off position Inside the drum under the filter is 2 long skinny strips of metal mounted in ...
Dryer will only run on auto sense My dryer will only work on auto sense drying. It will not run on Time dry setting. Your timer is bad.
...auto-sensing secondary master hard disk drive". What is possible reason this problem can be?What should I do??can i fix this problem by format the PC?? thanks.. The auto sensing isn't a problem ...
...sensing foil ? when auto-recerse switch is in one-way or continuos reverse the machine refuse to play back forward ,is it ok ? thank you , I'm pretty sure the auto-reverse is NOT supposed to work ...
Question about TEDX640JQ Electric Dryer
Whirlpool gas dryer (WGD9450WR1) not drying on auto-cycles On auto cycles the timer seems to go faster than normal. It would start at 55min for example, but then go down fast and be done in 15min with
Question about 7.3 Cu. Ft. Super Capacity Electric Dryer
samsung dryer running constantly in auto sense mode it is heating up and keeps adding time to any of the auto sense modes even after the clothesare well dried. Left it run just to see and it ran for ...
Question about 7.3 Cu. Ft. Super Capacity Electric Dryer
...Switches Support GE/10GE Auto-Sensing? The 10GE front subcards of the S5700-EI do not support GE/10G auto-sensing, and 10GE front subcards of the S5700-HI and S5700-SI support GE/10G
Question about 7.3 Cu. Ft. Super Capacity Electric Dryer
I have a Simpson auto sense dryer 39S505EM. it drys on the manuel timer phases - when select the auto sense phase it does not heat at all. could this be the moisture sensor or more likely the PCB? ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions