Questions & Answers for: back light switch 1998 ford

Light Switch ADJUSTMENT---- The Switch Needs to be CLOSER to the PEDAL ARM ,So ADJUST IT that wah BY Carefuly PUSHING "DOWN" on the Switch untill you get the desired Adjustment. If by Chance this DOES

Ad

...light stays on etc My Windstar has two real funky electrical quirks. 1. The dome ligth will just stay on Most times after carrying passengers that open the side door or the back door - the "open door ...

Ad

back where we started.....the interior light is again staying on! (so we removed fuse #29, but that also "killed" the windows - oops!) HELP!!!! If you are getting a dinging then it is more than likely

...the code after driving vehicle for a bit check engine light back on same code 117 what next???? make sure the car is getting up to normal temp. around 190 to 210 if not you may have a bad ...

...light comes on and the engine code is for both sides runner controls; the odds of the two sides going at the same time seems impossible, how can this be fixed? actually, I believe both runners are ...

Question about 1998 Windstar

1 Answer

switch which also controls the panel brightness. I have had this problem three or more times before. I have had to change the sensor, contacts cleaned and what ever the ford sevice could do to fix the

Question about 1998 Windstar

1 Answer

...back hatch the inside lamps stay on on when i turn the key on the door ajar light is on how do i fix this it just started the other day the easy fix would be to find door light switch and disconnect ...

...light is on, im pretty sure its my side door in my 1998 ford windstar, how do i replace that sensor? and what is it called ? its called a courtesy switch and most of the time you can pull back rubber ...

...back on. ignition key cylinder seems well worn and sloppy. there are two elec connectors that seem to have been attached to the housing for the cylinder. they are broken and seem to be of no use to ...

Question about 1998 Windstar

2 Answers

...Files: what I strongly suspect is the hazard lights control switch on top of the steering column may be broken and stuck on the 'off' position causing the hazard front and back lights to not

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...