Questions & Answers for: Jacuzzi get back off

...off, then back to the on position, all I get is a humming noise for maybe 15 seconds then a click and it shuts off . thank you Has the motor seemed a little slower in starting than usual? If so then ...

...5 HP CENTURY SPA PUMP AND MOTOR, STARTS AND RUNS OK FOR A WHILE , WHEN I SHUT IT OFF, AND TRY TO TURN IT BACK ON IT ONLY HUMS, IF I SPIN THE SHAFT IT WILL START, ALSO IT WILL START OK WHEN IT COOLS ...

...back cover off motor use 7/16 wrench to hold shaft unless it has a place for a flat head screw driver at the back of the motor while holding shaft unscrew impellar counter clockwise take shaft seal ...

...back and forth to get it off the shaft. To remove ether type of seal you may have to worry it off as the rubber on the seal will stick to ether the motor shaft or the impeller shaft with time. After ...

back of the motor on/off until you get to the point where the motor has cooled down and will turn back on. if you do not push the air button after the tub shuts down and you finish your bath then when

...off at the circuit box. This sound like a air switch problem. Open the access port and look at the back of the pump assembly. If there is a clear tube coming from the back of the pump most likely it ...

...off the nut that holds the air switch in place. Reinstall the air switch by putting the two wires back onto the air switch and put the cover back on the box on the motor. rod us parts center ...

...off back can't fine where to put back The hose under your tub attaches to the bottom of the air button and to the air switch located on the back of the pump or on the box on top of the pump. US Parts ...

Toilet handle came off need to know how to put it back on put it back in hole and turn nut back on

...and see if you feel debris. If you can't reach or if there is debris you will need to open the back of the pump, take off the diffuser, and clean out the impeller. possibly wired in reverse if 120 ...