...bad. When you go for cubed ice that solenoid should pull up the metal rod on the ice bucket so full cubes will come out. First check to make sure the metal rod on the ice bucket isn't somehow caught ...
Question about FRS3R5EMB Side by Side Refrigerator
...didn't use enough ice and should start filling a glass daily with ice. Didn't help. a bad valve will make them stick togather and sometimes hollow but the ge is well known for the back board being ...
Question about GSS20IEPWW / GSS20IEPCC Side by Side Refrigerator
this answer all the best regards There is a solenoid which mechanicaly switches the ice dispensing mechanism between crushed/cubed. This solenoid is either bad or jammed or has bad electrical contacts
Question about FRS26R4A Side by Side Refrigerator
...door does not dispense water. Ice Cube maker continues to make ice cubes Water dispensing solenoid is bad. You need to replace the solenoid valve. This typically is independent of the ice
bad water valve. if your ice maker has ice in it but had been making small cubes you should check to make sure you don't have a jam. small cubes could be from low water pressure or a blockage. if your
Question about HSM25GFRSA
...maker only gives crushed ice but no cubes you have bad solenoid, it is a small part next to the motor behind the ice bucket. It lifts up the arm to let the cubed ice out of the dispenser
Question about HSM25GFRSA
help! Ice makers have heaters that loosen the cubes when time for harvest. Sounds like the heater on yours is bad, or maybe the ice maker itself is just bad. Most likely will have to replace ice maker
Ice cubes in ice cube tray get stuck you have either bad heater in ice maker or the coating is wearing off the cube holder (bottom of cube tray that water sits in)
Question about HSM25GFRSA
...ice maker has a bad motor module/circuit board. It is like a control board. This module reads a temperature sensor that indicates the water is frozen and ready for harvesting the ice cubes. Then it ...
Question about HSM25GFRSA
...out the ice bucket and check the metal arm and make sure it moves freely. Ice may have gotten stuck. Solenoid that switches from cubes to crushed may be bad. It would be inside the auger motor ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions