bad lid switch. When you open then close the lid you should hear a click. if there is no click you have a bad lid switch. on the lid itself you will see a plunger when the lid is closed it plunges the
Question about 22622 Top Load Washer
lid is raised during a spin cycle. Not agitating could be a broken belt, bad motor, bad motor coupling, loose linkage, bad electrical connections to the motor, bad timer, etc., etc. It's not simple to
...be a bad lid switch. You could also have a bad water pressure switch or a bad motor. If the machine drains and spins, the lid switch would be ok. The pressure switch or motor could still be at
...bad lid switch, a bad pump a clogged pump.when you open then close lid u should hear a click if so thats good. if no click your lid switch is bad. if you here a click lid switch good look elsewere, ...
...bad lid switch. Clogged drain pump. Bad timer. The most common reason for this symptom is that the lid switch is bad. The machine is not suppose to drain or spin with the lid up, so if the lid switch ...
Question about WHRE5550K Top Load Washer
...lid switch is bad you will get the D5 code again. Not only that if you have children around it is not safe to leave the washer un-attended with a bad switch because the machine will not stop spinning ...
...and paste Sounds like a bad lid switch. Your machine will not drain or spin with the lid open and if it has a bad lid switch it thinks that the lid is open. Hope this
Question about Ultimate Care II LSQ9549L Top Load Washer
bad lid switch,if you do hear the motor but no agitation you have a broken motor coupling.most likely you have a broken lid switch,close the lid,then open it around 6 inches,close it and open it a few
Question about Ultimate Care II LSQ9549L Top Load Washer
...bad. #2 drive coupling on motor to agitator is bad, #3 clutch is bad, Check out the switch first. If the lid switch is bad it will not send current to start the motor ( safety precaution ).
Question about Ultimate Care II LSQ9549L Top Load Washer
...No click no spin. With click if switch bad no spin. A qualified technician needs to replace the switch if bad. The lid removes easily of course power must be off by unplugging the washing
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions