Question about 2002 Explorer
...ball joint press. The ball joints are a part of the upper control arm. So you have to replace the upper control arms. On 2006-07 models, the upper ball joint is not replaceable. If defective, replace ...
...wheel? new ball joint, strut mount and sway-bar links all tight. usually it is a ball joint or tie rod or cv shaft. Those are the three main culprits C/V joint, tie rod bushings, wheel
...ball joints and the noise is still there; I purchased the upper and lower tie rods today as my last attempt to solve this problem; any help would be appreciated; The outer tie rod ends can make a ...
...Ball-Joint assembly. After removing the tire, you will need to pull the Tie-Rod Nut Retaining Pin before trying to take off the Tie-Rod Ball Joint Nut. After the Nut is removed, you can use a ...
...tie rods and sway bar end links could be the problem,when you changed ball joints did you change both upper and lower ball joints?lower ball joints and control arm bushings tend to squeak loud when ...
...bearing Bad tie rod Bad ball joint Bad strut Loose lug nutsMost cases it's a wheel bearing but since you're getting a loud noise too, it could very well be a bad ball joint or tie rod
Question about 2002 Taurus
...ball joint problem jack the car so the wheel spins freely, take both your hands and place one on top of tire an the other on the bottom of the tire and wiggle the tire ,make sure you try to move the ...
Question about 2002 Taurus
...ball joints& passenger side upper motor mount.none of these have changed this noise even slightly What noise? And year and make of car? A clicking noise on turns is a worn CV joint on the axle ...
Question about 2002 Taurus
...ball joint if bottom feel/noise poss bottom ----move wheel side to side and look and check tie rods if loose or noise inspect and replace if damaged or worn ---remove wheel and inspect the joints and ...
...ball joint on lower control arms and tie rod ends are worn out. When you drive in to the hole on the road your wheel drops down and on its way up make this noise. This is worn ball joint. Problems ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions