Questions & Answers for: Sony Handycam battery icon bmw

...to correct this issue. To see if you have this problem: Power On your camcorder (make sure the battery is fully charged). Check the LCD screen and verify that the display icons are turned on. If ...

...battery dies in 5 minutes. 1. When rewinding a tape, after about 30 seconds, it shows an eject icon and starts making a pinging sound. At that point, you have to take out the tape, put it back in ...

...icon is flashing fast and beeping. According to the manual it is a self service problem, but the solution is not given. This is a S reel fault. Remove the cassette,battery,cables. Re load all now and ...

battery will not charge. The icon flashes several times and then cuts out. I contacted Sony and they said that if the camera works with the AC adapter (it does), then the problem is the battery. There

...battery life icon, no sound, usually shows pixelated playback even if I take a tape recorded with another Sony mini DV that plays fine on the camera that recorded it. The camera was not dropped or ...

...battery icon. For a while I reset the cassette and it seemed to help, but now the unit clearly doesn't have the power to open or shut the cassette bay. This is even after I replaced the battery. Full ...

icon to eject along with a beeping sound. Sounds like this is a very common problem. The error message indicates that the Camcorder has detected an issue that may require a power reset. Step 1: Try to

...(located on end next to battery) to a picture of what looks like a tool box (it is the 5th icon from top). Next, press wheel in to select and press wheel again to set date and time. Hope this

battery being fully charged , or may be you see an icon in the display screen with the charge status. As far the 6.30 hr duration that you have mentioned, this duration reflects the time that you have

...battery was replaced some files were recovered by the camera but one was not. Its icon is a segment of broken chain on the camera's screen. The camera gives a message that the file could not be ...