...http://www.carlsalter.com/motorcycle-manuals.asp It sounds like the cylinder head is pretty well beat. I would suggest you put a different head on the bike. Google " motorcycle salvage honda ". ...
...part. I was a little taken aback by the price of the OEM rotor ($23 US) but it sure beats a towing bill on top of all the hassle. That was why I also bought the OEM cap ($25
...beat it? on the dist shaft there is an oring that seals at the engine if you remove your cap and then mark your dist so that you dont change the timing ,then remove the distributor and you will see ...
...heat to swell the metal to brake the corrosion, its not the best car to start learn how to change beats on, but if you do attempt it there is a small locking key on the drive shaft pulley it will ...
...'wobbles' ( like vertical- or camber) when the car is elevated. I suspect the wheel beating is bad. I see that there are torb bolts on the backside that hold on the rotor assembly. ...
...3: cheap flebay no name parts ? or seals. (junk is junk) 4: shaft is damaged, 5: bearing worn allowing (bouncing) seal to get beat to death. good seals fail for #5 reason, top reasons, all
...shaft beat the slip ring brushes inside to dead. bad ALT, or the belt fell off, and is dangling inside and is touching a pulley and making racket. open the hood, have any mech. look there, see if the ...
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions