Question about Forest & Garden 125c 17" Curvgastrimmer
Trimmer head wont spin on Husqvarna 125c. It seems to be bound up. The drive shaft is not seated into position properly or the shaft has broken. Have you had the shaft off recently? If so, take the ...
Question about Forest & Garden 125c 17" Curvgastrimmer
the trimmer head stopped turning What could be wrong Husqvarna 225L trimmer the trimmer head stopped turning What could be wrong here is web site for parts http://www.partstree.com/parts/?lc=husqvarna
...shaft where it connects to the pump causing this condition...if you have the manual the mower came with ..you need to go to the procedure for bleeding the air out of the pump....if it is not in the ...
I bought the Husqvarna 128ld today and assembled it easily.... until i went to put the two shafts together. Now, i did put a different trimmer head on it before i did anything but i am pretty sure ...
I bought the Husqvarna 128ld today and assembled it easily.... until i went to put the two shafts together. Now, i did put a different trimmer head on it before i did anything but i am pretty sure ...
detachable shafts will not go on. Removed edger and tried to put weedeater shaft on and now neither will go on. check flex shaft,inner part of the larger housing,be sure the end is not ...
Question about 128 LD Weedeater
Needle threader doesn't move and stays in the low position. Husqvarna designer SE This could be due to one or more causes. 1. The return spring has come loose. 2. The threader shaft is bent. 3. Lint ...
Question about 128 LD Weedeater
ON A HUSQVARNA YTH21K46 THE SPLINES ON THE SPONDLE SHAFT AND THE PULLEY ARE GOING SMOOTH IN A VERY SHORT TIME Once the spindle shafts are damaged they cannot be reused. The spindle shaft(s) must be ...
Question about 128 LD Weedeater
I replaced the upper shaft in my Husqvarna 128 CD and it ran good for 30 hours. The engine will turn the upper shaft. When I add an attachment the shaft will not turn the attachments. Any suggestioms?
Question about 128 LD Weedeater
...the pin do to this shaft being seized due to some rust . Why they didn't add a grease nipple there beats me . Is it safe to heat this shaft This shaft runs into the gearbox selector, it may be an ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions