Questions & Answers for: Subaru beat shaft

turn the engine over 2 complete turns by hand in a clock wise rotation, and recheck all marks. Sure beats pulling all the covers again because one cam is a tooth out

...beat to hell 240,000miles but its all i got so dont offer by a new car im broke. I drove the car for a while almost bone dry on gear oil that could have attributed to the failure of the reverse. Any ...

...the boot, grease and figure the time it will take you, along with the constant slide hammer beating, then you will decide to purchase an entire axle with a lifetime warranty somewhere. Stay ...

Replacing head gaskets leaking head gaskets You have to take a lot of parts off to get to the cylinder heads. Intake manifold..vacuum hoses..sometimes the timing belt. You better get a Haynes or ...

1998 impreza outback, Im having a problem with left head lamp being dim, Changed old beat up plug that powers bulb. Bulb is good, Cleaned ground where wires come up from fender well. Dash high beam ...

...Checked timing mark with timing light and it's where it needs to be (15 BTDC) but light skips a beat from time to time and exhaust is not purring steadily but also skipping a beat as if it's on;y ...

cv shaft has a lot of play where its pinned to trans , bad cv or trans output shaft? hi it would more than likely be a bad cv as the trans would vibrate or knock if it had excess play in the shaft

left rear toe adjuster seized how to replace Sometimes you can spray these with penetrating oil and beat them with a hammer to free them. I have had to use a sawzall to cut the bolt between both side ...

cv boot failure The best thing to do is completely remove the front drive shaft (assuming you are talking about the front CV boots).1) Jack up the front end of the vehicle.2) Remove front wheel(s), ...

Trans fluid leaking out cv joints after clutch change? Fairly constant drip. Has the mechanic over filled or not put seals in properly? Subaru Forester 2006 I believe the Half Shaft is totally ...