...beat it? on the dist shaft there is an oring that seals at the engine if you remove your cap and then mark your dist so that you dont change the timing ,then remove the distributor and you will see ...
...heat to swell the metal to brake the corrosion, its not the best car to start learn how to change beats on, but if you do attempt it there is a small locking key on the drive shaft pulley it will ...
...'wobbles' ( like vertical- or camber) when the car is elevated. I suspect the wheel beating is bad. I see that there are torb bolts on the backside that hold on the rotor assembly. ...
...3: cheap flebay no name parts ? or seals. (junk is junk) 4: shaft is damaged, 5: bearing worn allowing (bouncing) seal to get beat to death. good seals fail for #5 reason, top reasons, all
...shaft beat the slip ring brushes inside to dead. bad ALT, or the belt fell off, and is dangling inside and is touching a pulley and making racket. open the hood, have any mech. look there, see if the ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions