shaft, and cannot get the ball joint to come out. any ideas beat them you need to take off the control arm. the ball joint is pressed into it and it does not come off unless you press it out in a vise
...it is not an easy task ! Please do not try to beat the shaft out, as this will mushroom the shaft and you will never get the fan off, another alternative is to buy a new fan blade, hope that ...
...and am tring to replace the hanging bearing. However I can not remove the old one. Is there a trick to this? I took a BIG hammer and wedge and beat the hell out of it until it released from the
does'nt work i would heat tghe hook up with a torch and beat on it up,If that does'nt work i would cut the shaft and replace the shaft and hook.I bet if you beat on it (takes time) you will get it off
Question about D300 Stand Mixer
...saturan vue but i cant get the inner hub off the spline shaft i assume you removed the nut that holds the spline shaft on the hub? try wd40 and put the nut back on a few turns and beat it with a ...
...shaft removeal. Have retainers off at axle & shaft seems frozen or rusted in place. Do I beat it out? Ant tricks? I use a pry bar myself I would not beat it with anything more then a rubber ...
...beat the **** out of end of shaft<(definitely ruined for core return) shaft wont budge. Use a piece of scrap 2x4 and place it on the end of the axle shaft and tap it with a hammer or mallett to ...
shaft should just come out of the spindle, after you beat it with a hammer...lol, but seriously, and then the other side you need a special tool it is a 2 prong fork, to pry between the tranny and the
Question about 1994 Ranger Supercab
...the pin do to this shaft being seized due to some rust . Why they didn't add a grease nipple there beats me . Is it safe to heat this shaft This shaft runs into the gearbox selector, it may be an ...
Question about 1994 Ranger Supercab
...shaft can I just beat it off ? I can't get the old bearing off the drive shaft, is there a special way of getting it off It's a 2005 Ford Escape XLT 4x4 A bearing puller, free to hire with a deposit ...
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions