leaking from main shaft Maytag top loader I have a leak from the main shaft coming into the drum from the bottom. How do I remove the drum to check the seals? you need to take the panels off, and then
clicking noise my washer is making a clicking noise, but not through the whole cycle. the clicking sound is very loud. the machine still finishes the cycle center bearing that holds the shaft is bad ...
Question about Neptune FAV6800AW Top Load Washer
Neptune washer will not go past the first wash cycle I have a maytag neptune top load washer and it will not go past the first wash cycle. It gets to a certain point and then it spins for 5 seconds ...
...appears to be excess fill time. I cleaned the screens on the fill lines and it hasn't missed a beat since.
Question about Neptune FAV6800AW Top Load Washer
bad pump??? Bought used and did a few loads OK but lots of sand/small gravel came out discharge. Fifth load would not drain basket. Error code said drain failure. Went to troubleshoot/diagnose mode ...
what does lr mean it stands for a "Locked-Rotor" on the motor shaft,most times if the motor shaft is free it becomes the control boards fault,and maytag makes an updated board and motor to resolve ...
machine rocks, all four sides, removed and oiled clutch bearings, tightened the belt, still rocks and errors out no matter the size load, machine is balanced. ? I feel you still have a clutch problem.
Question about Neptune MAH5500B Front Load Washer
When my washer is in the spin cycle, it has begun to spin very fast. It is about 10 yrs. old. The sound that it makes is extreme and frightning! should I be concerned? Yes, I believe that the sound ...
Question about Neptune MAH5500B Front Load Washer
...The reason the noise continues is that the shaft wobble even as minor as it may be ends up beating the new bearings to where they start making noise again. The new kits are better designed ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions