Questions & Answers for: blade cx 2

Rudder control very slow on CX 2 When turning nose right or left the turns are so slow. Do I need to adjust gain or do I have another problem? sounds like your servos are weak or just slow you can get

...cx and had to replace one lower and one upper main blades but now my helicopter wont fly it just keeps flying in circles. please help thank you. Spinning is caused by one of the main propellers ...

when left rudder input is engaged the heli will not spin Make only right hand turns.

cx2 I dont have much forward when I try to drop nose it does not move much.any ideas thanks how do i check the amperage on my cx2 batters

...would suit the CX. You would also need a carby balance adjusting tool. It' like a super long flat bladed screwdriver that goes inside a super long extended 8mm socket. "Motion Pro" do one, as do

will not lift off over weight or motor not reaching necessarry RPM, are all adjustments proper?

...Can you supply them. I believe they are Sapim cx-ray but I dont know for sure. They are black and bladed. The front wheel has 14 spokes and the rear has 16. Please help! I love these wheels the

...cx 4300 and have endless problems with all epson products , please solve it. try pulling the cartridges back out and make sure that all of the tape is off of the back and bottom of the electrical ...

...cx 3.8 v6 first take hose off, or drain from drain plug. antifreeze is what you are draining. Then get a 15 mm rachett and socket and pry tension pully back so you can remove belt. unbolt water pump ...

...cx9 and how do you replace it Just take the ring off of the fob and it pops open. Insert a knife blade or something similar to open it. Radio Shack or Walmart will have the battery. ...