Questions & Answers for: Chrysler blend door

heater runs on high without command,sometimes unable to shut-off You need to check your blend door. It sounds like its stuck on heat. Your blend door would be the switch that changes from hot to cold

...not block air, so it is unlikely that the blend doors are the problem. Your mechanic needs to check the operation of the re-circ door and if its fault replace it.Thanks. Hope you rate my ...

Blend doors not blending, only blowing out hot or cold, no in between. I do have the dual climate controls in my car, I can blow cold on one side and hot on the other, or I can match them to be the ...

...blows out dash vents on a/c setting, cold air blows out floor and defrost on a/c setting Often a sign of a blend door problem.  The blend door or doors are in the heater a/c box behind the

...Blend Door Failure No Heat In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is ...

...how do I access and fix? Hopefully it's the switch behind the dash. I would try replacing your selector switch before messing with the blend door. You have to pull the dash out to access the blend ...

...blend door actuator located and how to remove it its in the HVAC heater core box, how to remove it is a very long answer. read the FSM on HVAC or login to alldata.com see HVAC chapter, and read. ...

...blend door in 07 Chrysler sebring The most likely problem is either the blend door actuator or a broken blend door itself. Both are only accessible by complete removal of the instrument panel(dash). ...

I have a 2008 Chrysler Sebring. Were is the blend door located? the blend door blends the hot and cold air from the dash that's used to heat and cool the passenger compartment

...blend door actuators give errors but do turn on selftest modus on ATC. The error shown on display are 4 items, 23, 24, 32 and 33: 23: Blend door actuator feedback failure (bad servo) 23: Blend door ...