...blend door that is know to give problems. Sometimes the blend door itself will break but there is also a blend door actuator that can fail. The blend door actuator is located behind the dash...kinda ...
blend door is not working right or the in car air temperature sensor is faulty. Removal & Installation Air Inlet Door Vacuum Motor To Remove: Remove the instrument panel. Remove the air inlet door
...blend door over to heat. I would inspect for a broken vacum hose somewhere. The blend door in your vehicle needs all vacum hoses to not be leaking in order to switch over. check to see if the blend ...
...Blend Door Failure In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called ...
...Blend Door Failure No Heat or no AC (dependes on where door sticks) In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air ...
...blend door actuator went out. i replaced it and everything works great for a couple of weeks. then loud clicking noise came back. i removed blend door so i can get a replacement. however, with no ...
Question about 1996 Ranger SuperCab
...blend door and accuator but accuator will not work The blend door failed and I replaced it. Upon checking to see if my work was sufficient I found that the actuator for the blend door was not ...
Question about 1996 Ranger SuperCab
...Blend Door Actuator Removal - YouTube ? 12:29 https://www.youtube.com/watch?v=dYPOtin3JUk Dec 1, 2013 - Uploaded by FordTechMakuloco Only buy the Ford Actuators, you can get them cheaper here- ... ...
Question about 1996 Ranger SuperCab
blend door module clicks blows out cold air no warm air? The air temperature blend door is jammed and this is causing the blend door motor to "skip". REMOVE THE DASH ASEMBLY AND REPLACE THE BLEND DOOR
Question about 1996 Ranger SuperCab
blend door actuator maybe . Does your vehicle have manual or automatic temp control . Taking to a qualified repair shop that can read code's in the HVAC control module would be a good place to start .
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,347 Questions
2,636 Questions