door blend actuator, but if it is only 5 months old take it back to the dealer and have them complete the warrenty. The same happened to my Journey 2010, I removed the rear seats, the covers and found
...blend door is probably stuck. the blend door is a flap in the heater box that moves back and forth from the heat side to the A/c side. may be the thermostat is at fault in ur journey. take ur ride to ...
Question about 2009 Journey SXT
...blend door motor, or the actual door is broken inside the heater box. Jeeps used to have this issue, the door shaft snaps and only half will work. If you can turn from hot to cold on the side that's ...
...blend door actuator I have a clicking noise when I turn on my heater on the passenger side. If you hear clicking, the actuator has most likely broken one of its teeth. A common problem. You need to ...
Question about 2010 Journey SXT
...cool air on passenger side and loop warm air on drivers sided i pulled my dash out and check the blend doors they are opening and closing when you change temp. I heater not getting very warm hose ...
of air on the passenger side only. Drivers side works according to settings. blend door motor is bad or blend door is stuck. You will need to remove most of the dash to access it...not a beginners job
...blend door is the problem. most likely the actuator ( the motor that runs the blend door and controlled by the module) is not operating properly. your dealer will hook the module up to a diagnostic ...
Question about 2010 Journey
...These are different than the mode doors, which direct the airflow to floor, dash, defrost, etc. Apparently the blend door for the driver's side is working, but not the one for the passenger's
Question about 2009 Journey
...but not on the passengers side or the back. Help Please The 'blend door actuator' is broken or stuck. Access is from the side of the centre console under the glove box. 2009 Dodge Journey Google ...
Question about 2009 Journey
...For the passenger heating, that one is easy, blend doors stuck, blend door actuator failed, or a linkage has come off. Videos show how to get there and
Usually answered in minutes!
449 Questions
168 Questions
93 Questions
40 Questions
43 Questions