Questions & Answers for: Isuzu Rodeo blowing 40 amp fuse starter

...30 to 50 used this will save alot of run around trying to rebuild . disconect battery remove 2 starter bolts , drop it down and remove wires from starter be careful it they look rust use wd 40 if ...

...90 model, had to keep clicking on the ignition key until it started, auto electrician said I need a recon starter $300+ dollars but I bought 2 new brushes $5 and put them in and had no more ...

...starter works, plugs have spark, can hear the fuel pump come on but no fuel pressure to the engine REPLACE FUEL FILTER COULD BE STOPPED UP.ALSO YOU COULD HAVE BLOWED FUEL INJECTOR FUSE OR FAULTY ...

...40 Nm).Starter wiring connectorsHeat shieldExhaust front pipeHeated Oxygen (HO2S) sensor connectorsNegative battery cable Starter motor. Tighten the bolts to 30 ft. lbs. (40 Nm). Starter wiring ...

...amp fuse between the battery and the ignition switch that could be defective. 5) The ignition switch is defective. When you do use the screwdriver, are you putting the key in the "ON" position? This ...

fuse named IC keeps blowing as soon as it is put in ...what is the IC ? It could be integrated controller or ignition control. Do you know what circuit is dead after the fuse blows ? Or where the fuse

...you are using the proper fuse. If so, disconnect the starter solenoid and then try to start the vehicle. If the fuse does not blow, the starter solenoid (entire starter, actually) should be

...fuse 20 amp how to fix 20 amp ignition fuse under dash blows everytime turn on the key. replaced the ignition already no help all relay test ok not sure how to find my short wire up headlight globe ...

...starter too.. but always check fuses first as an added precaution, check your ignition wires are sound (is the key loose in its cylinder ?) sounds like grounding though....having replaced those two ...

...amp; use an air hose to remove any water you find You have water intrusion past the Weather-pak seal on the wiring harness to the starter solenoid relay. You can try spraying WD-40 or similar ...