stripe running down the middle of the monitor. What is the cause of this and is it repairable? Thanks a lot for any help. I must say thanx to Bogdan, his suggestion really did helped to fix my Dell :D
Question about UltraSharp 2001FP 20.1" LCD Monitor
Color distortion/blank screen on 50% of monitor Two problems, probably related: 1) There's a 2" wide vertical stripe of color distortion. From straight black, the stripe appears a dark gray at normal ...
Question about UltraSharp 2001FP 20.1" LCD Monitor
Connect Digital and Analog cables at the same time.Any use? Does it help any to have the blue and white connectors connected to the back of the computer to the monitor at the same time? (The digital ...
2" pink stripe I have a 2" vertical pink stripe down left side of monitor. this is the 4th monitor to do this on me. It sounds like it is either the video cable or the video causing this if it is ...
Question about UltraSharp 1704FPT 17" Flat Panel LCD Monitor
my monitor goes half red pin striped and black w/ some visibility my monitor goes half red pin striped with some visibility and half black and red pin striped with nothing visible the options are ...
Question about UltraSharp 2001FP 20.1" LCD Monitor
...LCD monitor with an intermittent 2" wide gray stripe down the middle (you can see through it) that I was told was a back light failure. Is that true? If so, what is the correct replacement part? I'm ...
the monitor just shows colored stripes The most likely problem here is a lack of drivers. To test it, see if you can start your computer in safe mode. If you are still getting only stripes no matter ...
...stripe down the left side of my HP laptop display screen. What's up?? It probably means that you're very lucky that your screen is failing and probably NOT the Video Card on *********** board. Either ...
Question about UltraSharp 2001FP 20.1" LCD Monitor
i have just bought a used Dell Ultrasharp 3007 30 inch monitor, I connected it to a G5 quadcore MAC computer with an NVIDIA 6600 video card, I have two DVI video ports, on one port the display can ...
...blue setting is too high in one line(about 2 inches wide) Try reseating the ribbon cable between the T-CON board and the LCD panel first, this problem can be due to bad T-CON or LCD panel. It is ...
Usually answered in minutes!
101 Questions
94 Questions
96 Questions
77 Questions
74 Questions