Question about CS6000i Computerized Sewing Machine
...bobbin tension on this machine. Any ideas would be appreciated. it sounds like your bobbin tension is too tight. to adjust bobbin tension, remove bobbin case (remove needle plate first) and adjust ...
Question about CS6000i Computerized Sewing Machine
...BOBBIN TENSION SINCE LAST CHANGING BOBBIN CASE FOR MACHINE EMBROIDERY. BOBBIN TENSION NOW IS EITHER TOO TIGHT, AND THREAD PULLS DOWN TOP THREAD, OR AS NOW, BOBBIN THREAD LOOPS. IS THIS A TENSION ...
...bobbin tension ======================================or loosen top tension. 2.forming loops on bottom of cloth====Tighten top tension 3.Bobbin placed in case incorrectly===remove and replace 4.Bobbin ...
...tension. Take the bobbin out of the bobbin case and reload, make sure that the bobbin is in the right way and then hold the bobbin still and press the thread tail into the tension spring until you ...
Question about PS-1250 Pacesetter
tension on the bobbin case is as follows. Load the bobbin into the bobbin case and pull the thread tail into the tension spring, then suspend the bobbin by holding the thread tail up in the air
...on the bobbin case but if U cannot readjust the tension, it means that ther is somthing between the tension blade and the bobbin case body. Remove the tension blade, clean and
Question about LS-2125 Mechanical Sewing Machine
...bobbin tension problems" and "top tension problems" is almost always a slight misthreading of the sewing machine. Unless you're doing something really strange, like silk ribbon embroidery done by ...
...bobbin tension lower. You need to check for threads stuck in the bobbin tension and clean them out. The thread should feed out of the bobbin tension with a small amount of tension. Make sure your ...
Question about LB-6800PRW Project Runway Limited Edition Combination Machine
Bobbin Tension? Same fabric, same threads, same tension (4), but now bobbin thread showing on right (up) side of the fabric. Only starts to improve when top tension set to 0. Bobbin case tension screw
Question about LB-6800PRW Project Runway Limited Edition Combination Machine
...in the middle of the fabric--this is correct tension. If loosening the top tension doesn't do enough, then you may need to slightly tighten the bobbin tension. Understanding Thread Tension Threads
Usually answered in minutes!
764 Questions
337 Questions
294 Questions
223 Questions
181 Questions