...the ignition switch electrical connector. Remove the ignition/shifter interlock cable mounting bracket bolt and position the ignition/shifter interlock cable mounting bracket and the ...
... on the battery. The black with is negative ( - ), and is connected to a ground...meaning a bolt or bracket. Hello. Begin by turning off the radio if your car has one. Next be sure that you buy a ...
...three electrical connectors located above the transaxle. Remove the electrical connector support bracket. Install Engine Support Bar 014-00750 or equivalent, and attach it to the engine lifting ...
How do I remove the turn signal/light switch from a 94 Mercury tracer. TURN OFF RADIO FIRST TO KEEP FROM LOCKING IT OUT.DISCONNECT NEGATIVE BATTERY CABLE WAIT 20 MINUTES FOR AIRBAG TO DISCHARGE ...
...fuel filter for 1998 mercury tracer Usually there is a worm gear clamp holding the filter to the bracket. There are 2 plastic clips, one on each connector going to the fuel filter, remove both ...
...make it start then remove a spark plug wire and place it near a metal object like the motor or a bracket and have someone try to start it and watch for sparks, if theres no spark then you may want ...
...wiring connector to the ignition switch. Remove the ignition and shifter interlock cable mounting bracket bolt and position the assembly to one side. Remove the four steering column bracket bolts ...
Question about 1997 Tracer
...that will probably end up burning your car to the ground?The entire switch, tumbler and mounting bracket assembly is available from AutoZone. 1997 Mercury Tracer Ignition ...
Question about 1999 Tracer
I HAVE A 1999 MERCURY TRACER THE TRANSMISSION MOUNT BRACKET IS IN THE WAY TO GET THE TRANSMISSION PAN OFF ANY IDEAS?? IM REPLACING THE TRANSMISSION FILTER AND WHEN I TRIED TO REMOVE THE PAN THE ...
Usually answered in minutes!
157 Questions
123 Questions
136 Questions
106 Questions
78 Questions